What should I do if my parking brake is not released?

What should I do if my parking brake is not released?

The first few steps are to drive the vehicle on to a level surface, shift the transmission into “Park” and turn off the ignition. Make sure the emergency / parking brake is “OFF”. If the parking brake is not released, you will not be able to pull the rear caliper off the old pads and out of the bracket.

Is it safe to retract electric parking brake?

The next safest option is to use an OBDII Scanner (also known as an OBD2 scan tool) that specifically has the ability to retract the electric parking brake system. Attention: Please proceed with caution and at your own risk!

How do I release the electronic parking brake?

If you just need to manually release the electronic parking brakes in order to move a disabled vehicle, you can skip past the steps for removing the rear caliper. Loosen the top and bottom caliper bolts by turning them in the clockwise direction (as seen from the outside of the vehicle).

How to tighten EPB on Honda parking brake?

Tighten the two EPB bolts in the clockwise direction with the 5mm hex head socket and a ratchet or the 5mm Allen key until they are snug. Try to avoid over tightening the bolts to prevent from cracking the plastic housing. For example, the torque specification for the EPB housing bolts in a Honda service manual is just 5.9 lb-ft (or 8.0 N-m).

Do you have to use all leveling jacks?

The PowerLevel system performs the dual function of leveling the vehicle and, once a level plane has been achieved, stabilizing the vehicle. When leveling the vehicle, it may not be necessary to use all of the leveling jacks however, to stabilize the vehicle, all jacks should be extended to contact the ground. SITE SELECTION 1.

How does a manual hydraulic leveling system work?

For Manual, Automatic and Remote Leveling the vehicle engine must be running, the transmission in park and the parking brake set. Securely block the rear wheels using wheel chocks. Locate the “ON/OFF” button on the upper right of the control panel. Momentarily depress this switch to activate the leveling system.

What is a power gear leveling and stabilizing system?

The Power Gear leveling and stabilizing system is an electronically controlled/hydraulically operated unit that consists of a 12 volt DC powered motor/pump/manifold assembly with fluid reservoir, hydraulic hoses, four