How to replace rotted wood in a travel trailer?

How to replace rotted wood in a travel trailer?

1 probe extent of damage and trace out boundary 2 cut out badly damaged areas 3 dry out remaining wood framing 4 apply mold-killing product 5 saturate it with thinned epoxy resin 6 if needed, replace or add additional wood framing

How big is a Shasta compact travel trailer?

Explore a vintage travel-trailer icon that brings a wave and a thumbs-up on every trip—our 1963 Shasta Compact Travel Trailer. 12.5 feet of beautiful birch interiors, packed with amenities and topped with wings.

What kind of rot does a camper have?

The white corner under the bench seat shows you the type of rot the camper had. The sub-floor was particle board that had been wet too long. Step 2: Out With the Old. So I was able to pull the camper into the garage and open it up. Then I used hydraulic jacks to raise it up on jack stands.

How to replace rotten framing in a vintage trailer?

The solution was to replace the rotten frame piece with a 2 x 6, so that we were rebuilding the trailer better than it was originally built. This 2 x 6 is the length of the beam we just removed and is marked to be notched out for the framing around the door frame, which we wanted to save.

How big is a Shasta vintage camper trailer?

This camper is a beauty, she was a sad looking camper when we got her. Neglected and abused, she now has her wings again and ready for her next adventure. Camper is 15′ and 3′ for tongue so total is 18′ If you have been shopping for a nice camper this would be a very nice one! Located in Lake Havasu City AZ. 86404 $14,500 PRICE LOWERED TO $11,700

How to replace rotted wood in an RV?

Once he knew where the damage was, Doug removed the vinyl floor covering and all the rotted wood. You may need to put your RV up on jacks to perform this step and ensure that all the old, rotted flooring is completely removed, both internally and externally. 3. Dry out the wood framing

The solution was to replace the rotten frame piece with a 2 x 6, so that we were rebuilding the trailer better than it was originally built. This 2 x 6 is the length of the beam we just removed and is marked to be notched out for the framing around the door frame, which we wanted to save.

Where was the 1970 Shasta travel trailer impounded?

On 2Feb16 I impounded a 1970 Shasta Stratoflyte Travel Trailer with no plates attached on Joint Base Lewis-McChord. The numbers I managed to get off the frame are 5560 and the data plate states manufactured in Washington. Is this the correct number? Sorry for the delay. Got busy at work.